Bayliner 265 Specifications Page 36

  • Download
  • Add to my manuals
  • Print
  • Page
    / 84
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 35
Chapter 3: Propulsion & Related Systems 265 Owner’s Manual Supplement
30
Quick Oil Drain System (Gas Engine Only)
The quick oil drain hose was attached to the engine oil pan at the factory. However, some minor assembly is still
needed before you can use this system.
How to install the quick oil drain system:
1. Unscrew the factory installed
garboard drain plug from the gar-
board drain (A). Keep the factory
garboard drain plug on the boat
as a spare.
2. Un-clip the quick oil drain
assembly from the wire loop (B)
on the engine.
3. Un-clip the draw cord section
(C) from the draw cord
section (D).
4. Thread the draw cord section
(D), the oil drain plug (E), and
the oil drain hose (F) through the
garboard drain (A).
5. Adjust the hose stop clamp (G)
so that no more than 12 inches of
hose, including the oil drain
plug, can extend out of the gar-
board drain (A).
6. Re-clip the draw cord section (C)
to the draw cord section (D).
7. Push the oil drain hose, oil drain
plug, and both sections of the
draw cords through the garboard
drain and into the bilge area.
8. Screw the oil drain garboard
drain plug (H) into the garboard
drain (A) and tighten firmly.
To drain the engine oil:
1. Remove the boat from the water.
2. Unscrew the garboard drain plug.
3. Pull the draw cord until the oil drain plug and the oil drain hose slide out of the garboard drain.
4. Place the end of the oil drain hose into a suitable container.
5. Unscrew the oil drain plug and drain the engine oil.
6. Replace the oil drain plug.
7. Push the drain hose back into the bilge.
8. Replace the garboard drain plug and tighten firmly.
Always
dispose of waste oil in accordance with local regulations.
QUICK OIL DRAIN SYSTEM
ENGINE
TRANSOM
BILGE
FACTORY
INSTALLED
OIL PAN
A
C
H
D
E
F
B
G
Page view 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 83 84

Comments to this Manuals

No comments