Bayliner 2859 Classic Cruiser Specifications download pdf (Page 34)

Chapter 6: Plumbing 2859 Classic Cruiser • Owner’s Manual Supplement

Marine Head with Holding Tank

• Read the marine head operation and maintenance manual (included in your boat’s owner’s packet).

• The holding tank is plumbed to a waste fitting on the deck for dockside pump-out.

• Check the content level of the holding tank by looking at the side of the tank.

• Empty the holding tank at every opportunity.

Winterizing The Marine Head

1. Shut Off the pickup seacock and pump the head until the bowl is dry.

2. Remove the drain plug in the base and pump again to remove all of the water.

• Do not fill the bowl with anti-freeze.

• Close the pickup seacock while the boat is underway or whenever the boat is left moored in the water.

Operating the manual flush marine head:

1. Open the head’s seawater pickup valve (seacock).

2. Before using the head, pump enough water into the bowl to wet the sides.

3. After use, pump until the bowl is thoroughly cleaned. Continue pumping a few more times to clean the lines.

4. If excess waste causes the water to rise in the bowl, stop pumping until the water recedes.

NOTICE

Check with local authorities for regulations regarding the legal use of marine head systems.

MARINE

HEAD

OVERBOARD DISCHARG

BALL VALVE

SEAWATER PICKUP

& BALL VALVE

MARINE HEAD TO

HOLDING TANK

PUMP-OUT

HOSE

HOLDING TANK

VENT HOSE

MACERATOR

OVERBOARD

DISCHARGE

HOSE

(IF EQUIPPED)

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 63 64

No comments

Bayliner 2859 Classic Cruiser Specifications Page 34