Bayliner 249 Specifications download pdf (Page 42)

Chapter 4: Propulsion & Related Systems 197, 219, & 249 • Owner’s Manual

Supplement

Quick Oil Drain System

The quick oil drain hose assembly was attached to the engine oil pan at the factory. However, some minor assembly

is still needed before you can use this system.

How to install the quick oil drain system:

1. Unscrew the factory installed

bilge plug from the bilge drain

(A). NOTE: Keep the original

factory bilge plug on your boat

as a spare.

2. Unclip the quick oil drain assem-

bly from the wire loop (B) on the

engine.

3. Unclip the bilge plug’s draw cord

draw cord (D).

4. Thread the oil drain plug’s draw

cord (D) through the bilge drain

(A).

5. Pull the oil drain plug (E), and

the oil drain hose (F) through the

bilge drain.

6. Adjust the hose stop clamp (G)

so that no more than 12 inches of

hose, including the oil drain

plug, can extend out of the bilge

drain (A).

7. Clip the bilge plug’s draw cord

draw cord (D).

8. Push the oil drain hose, oil drain

plug, and both draw cords

through the bilge drain and into

the bilge area.

9. Screw the bilge plug (H) into the

bilge drain (A) and tighten

firmly.

To drain the engine oil:

1. Remove your boat from the water.

2. Unscrew the bilge plug.

3. Pull the draw cord until the oil drain plug and the oil drain hose slide out of the bilge drain.

4. Place the end of the oil drain hose into a suitable container.

5. Unscrew the oil drain plug and drain the engine oil.

6. Replace the oil drain plug.

7. Push the drain hose back into the bilge.

8. Replace the bilge plug and tighten firmly.

Always

dispose of waste oil in accordance with local regulations.

QUICK OIL DRAIN SYSTEM

ENGINE

TRANSOM

BILGE

FACTORY

INSTALLED

OIL PAN

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 87 88

Comments to this Manuals

No comments

Bayliner 249 Specifications Page 42

Comments to this Manuals

Related products and manuals for Carbon monoxide (CO) detectors Bayliner 249